BERTSCHAT HEATED MITTENS PRO - DUAL HEATING, User Manual, Page: 6 / 45

6
• Does the LED on the charging cable not light up? The plug or charging cable is defective and does not receive any
power.
• Insert both connectors in the mittens in the ports of the batteries. Now place the batteries in the pockets inside
the mittens and then close the zip.
• The heating is switched on when pressing the black silicon ON/OFF button on the top of the mittens. The LED on
the silicon button lights up to confirm that the heating function is switched on.
• When the LED is lit up the mittens are heating: you should be able to feel the generated heat within 1 minute at
the fingers and at the top of the mittens.
WARNINGS
• The mittens are not suitable for use by minors.
• Do not make any changes to the mittens and/or battery.
• In case of damage to battery or charger, stop using the product.
• Leave the protective plastic around the battery.
• If the battery swells up, immediately stop using it and contact the supplier.
• Do not drill through the battery packs or make holes in the battery in any other way.
• Make sure the heating elements do not overlap while active and not being worn as this could lead to a situation
where the mittens overheat.
• This product is only intended to be used by people and should not be used on animals.
• The mittens can become very warm. If you have a reduced sensitivity to heat or cold, we recommend consulting a
doctor first.
• In case of a higher ambient temperature, the sensation of heat will be stronger. In that case, set the mittens to a
lower position that does feel comfortable.
• In case of incorrect use of the battery, there is a possible explosion hazard.
• Avoid direct skin contact with the heating elements as this could lead to skin burns. If you notice a hole in the
fabric or a visible heating wire, stop using the mittens and contact your supplier immediately.