BERTHOLD TECHNOLOGIES LB 480, User Manual

Page: 366 / 450

54733-10BA2L
3 – 366
02.2017
Menu Structure Volume 3
2.38
Test
Menu path: Device Config

Setup

Service

Test .
These menus allow you to perform various tests on the detector. All
tests have a direct influence and are not delayed by the time con-
stant.
If you lock the device with the password or if the Safety Mode is
enabled, all test settings will be disabled automatically.
1 Test Settings
Opens the menu offering various test options for the detector ( page
3-366 ).
2 I/O Test Settings
Opens to the menu offering various test options for the digital inputs
and outputs (
page 3-369 ).
2.39
Test Settings
Menu path: Device Config

Setup

Service

Test

Test
Settings .
This menu allows you to check your calibration setting by simulating
the measurement signal.
1 Level Mode
Here you can check if the process value is correctly transmitted
from the field device to the process control system.
To simulate a level reading, you have to:
1. Enter a level value at Level .
2. Select FIXED VALUE at Level Mode .
IMPORTANT
After the test, do not forget to switch from FIXED VALUE back to
NORMAL ; otherwise your measurement signal will remain frozen
at this value.
2 Level

Enter the value to be simulated.
To enable the simulation, you must set
FIXED VALUE at Level
Mode .