We recommend turning the gas burner to high to preheat the stone for approximately 30 minutes. Then
a few minutes before you are about to cook your pizza, put wood kindling/wood chunks in the back of the
oven on top of the wood burning tray for propane gas burner, and turn the burner knob to low or med/low.
If you have a non-contact infrared thermometer, try to get the middle of the stone to approximately 700-750F
and the back of the stone to 800-900+F. Rotate the pizza at quarter rotations approximately every 20 to 30
seconds.
WARNING: Only use this oven outdoors in a well-ventilated area. Do not use in a garage, building, breezeway
or any other enclosed area.
WARNING: Keep ventilation openings for cylinder enclosure free and clear from debris.
WARNING: Your Bertello Oven shall not be used under overhead combustible construction.
WARNING: Your Bertello Oven is not intended to be installed in or on recreational vehicles and/or boats.
WARNING: Do not use the Bertello Oven within 24 inches of combustible materials.
WARNING: The entire cooking box gets hot when in use. Do not leave unattended.
WARNING: Keep any electrical supply cord and the fuel supply hose away from any heated surface.
WARNING: Keep the cooking area clear of flammable vapors and liquids such as gasoline, alcohol, etc.,
and combustible materials.
WARNING: Never store an extra (spare) LP cylinder under or near the Bertello Oven.
WARNING: The LP cylinder used with your Bertello Oven must be with a listed OPD (Overfilling Prevention
Device) and a QCC1 or Type 1 CGA810) cylinder connection. The cylinder connection must be compatible
with the Bertello Oven connection.
STORAGE AND/OR NONUSE
● The gas must be turned off at The liquid propane cylinder then The Bertello Oven is not in use.
● When the Bertello Oven is stored indoors, the gas supply must be
GENERAL INSTRUCTIONS
General Tips for using the Gas Burner with Wood at the same time
Summary of Contents for Bertello One
