Preparing and loading dishes
Etching
Using too much detergent
The inlet water temperature
exceeds 150 F
Use less detergent if you have
soft water
Lower the inlet water temperature
Problem
Dishwasher
won't start
Dishwasher beeps at
the end of the cycle
Rinse Aid light on
Dishwasher operates
too long
Dishes are not clean
enough
Dishes not drying
enough
Spots and filming on
dishes
Possible cause
Power supply or power line is not
connected
The rinse aid level is low
The dishwasher is connected
to cold water
Water pressure is temporarily low
Detergent dispenser is empty
Water hardness is too high
Dishwasher won't start
Child Lock activated
(selected models)
It indicates the wash cycle
finished, the dishwasher will beep
The cycle time will vary due to the soil
The sanitize option is selected
The inlet water is low
Dishes are loaded too close
together improper use of
detergent
The selected cycle is not suitable
for food soil condition
Spay arms is blocked by
some items
Improper loading of dishes
The cycle you chose did not
included the drying.
Improper loading of dishes
Old or damp powder rinse aid
is used
Rinse dispenser empty
Add rinse aid
Check the dishwasher,make
sure it connected to the hot water
supply
Use you dishwasher when the
water pressure isnormal
Fill rinse aid dispenser or increase
the amount of rinse aid.
For extremely hard water install
a water softener
Deactivate the child lock, refer
to child lock section in this manual
When heavy soil is detected, the
auto, normal, pots&pan cycle will
automatically increase thecycle
time
When sanitize option is selected,
the cycle time will be increase to
meet the sanitizedtemperature
request
Load the dishes again as the manual
introduced
Add detergent depending on the water
hardnessand the cycle you chose.
Use fresh detergent.
Make sure the dishwasher is connected to
the hot water supply
Try not use your dishwasher when hot
water isbeing used elsewhere in the house
Choose anther cycle for longer
washing time
Make sure the spay arm is rotated
fluently
Load the dishes again as the manual
introduction
Choose the proper cycle with drying
Load the dishes again as the manual
indicates
Use fresh rinse aid
Add rinse aid to the dispenser
Delay Start option has been selected
Check and connect the power
supply
Shut the door completely make
sure it is latched
Refer to Delay Start section in
this manual to rese
Clean the door gasket
16
