DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS
LIGHTING AND OPERATION
JT539 / BZ4600SW
1. To light with match, do not hold the match directly in front of the torch opening. Rather, hold just below the opening as
shown.
2. Light match before opening regulator valve and then open regulator valve slowly by turning adjustment knob
counterclockwise until the torch lights. This may require up to 3 turns.
3. To light with spark lighter, open valve slowly before sparking. Hold spark lighter at a 45º angle to the torch opening.
NOTE: It is very difficult to light with valve fully open. Turn adjustment knob to obtain the proper flame as shown.
4. Turn adjustment knob to obtain the proper flame as shown.
•
To adjust the flame direction on BZ4600SW, grasp at base of burn tube and rotate burn tube to desired position.
•
Do not use torch with fuel cylinder tipped more than 60 degrees from its upright position as this may cause torch to flare
TS839 / TS99
1. Open regulator valve fully by turning adjustment knob counter clockwise until it stops. Do not force. Always fully open valve
when lighting to prevent damage to ignition system. Never look into the burner tube or point in unsafe direction.
2. Point torch in a safe direction and push the ignition button. Repeat if necessary while adjusting the valve slightly.
3. After the torch lights the ignition button may be released and the flame may be adjusted.
4. To adjust flame, grasp the regulator with one hand and use the other hand to turn the adjustment knob to the required setting.
•
To adjust the flame direction, grasp the torch body and rotate burn tube to desired position.
•
Do not use the torch with fuel cylinder tipped more than 60 degrees from its upright position as this may cause torch to flare.
ADDITIONAL WARNINGS
•
Make sure the torch is cool before lighting or removing burner head or before installing or removing accessories.
•
Check all joints and couplings periodically to insure against loose connections. With valve open, without lighting, test all
connections with soapy water. If bubbles appear, gas is leaking and torch must be repaired. Never use a flame to check
for leaks. Make this test in a well ventilated and spark-free area and where there are no open flames.
•
In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the cylinder to room
temperature prior to use.
STORAGE
REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1. Turn ignition button to the off position. Make sure regulator valve is closed by turning flame adjustment knob fully
clockwise until it stops. Do not force.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children.
Observe cautions on cylinder label.
3. Do not expose cylinders to temperatures in excess of 49°C (120°F).
4. Store cylinders in well ventilated areas.
JT539
Proper Flame
BZ4600SW
3/4” - 1” Propane
1/2” - 5/8” Map-Pro
Main Flame
Check out the collection of welding equipment & soldering tools we offer.
