10
HT01
Advanced Settings
Safety Information
7 Day Automatic mode
To select the 7 day timer mode press
M
until is displayed on the LCD screen. The thermostat will then switch
between comfort & energy saving mode (On/Off) automatically according to the day & time settings. Each day of the
week can be programmed with individual settings.
To set up the automatic mode, press & hold for 3 seconds.
To select the day of the week to be programmed press .
The bottom of the screen will show the following pattern of 24 numbered surfaces. Each field represents a 1 hour
period of a 24 hour cycle. Each of these 1 hour periods can be programmed to comfort or energy-save (On/Off) mode.
To enter advanced settings press and hold
M
for 3 seconds. Press
M
once again for each numbered function.
Temperature Calibration. If an accurate temperature read out from the room or floor differs from the read out on the
thermostat, providing the sensor has been checked against the stated resistance values, the thermostat can be calib-
rated using this function. The range is -8˚C ~ +8˚C.
Sensor Selection. See beginning of the Operating Instructions section for details.
When operating the thermostat with the
rFS
sensor selection, the room temperature will display on the thermostat.
This function allows the user to see the current floor temperature.
When operating the thermostat with the
rFS
sensor selection, this function allows the user to amend the maximum
temperature the floor can reach. If the floor temperature exceeds this over-heating protection set-point, ALARM will
flash on the screen and the heating output will cut out.
WARNING: RISK OF ELECTRIC SHOCK. Disconnect power supply before making electrical connections. Contact
with components carrying hazardous
voltage can cause electrical shock and may result in severe personal injury or death.
This thermostat is not a safety device and should only be used with safety certificated floor heating systems suitable
for their specific purpose. In order to avoid damaging your flooring, ensure the correct sensor selection & operating
temperatures are selected during the programming process.
1.
2.
3.
4.
To make changes to the timed program, press + / – to select the 60 minute period. Then press to select the mode.
Pr or – will copy the selected mode from the previous 60 minute period.
Whilst programming, inactivity of 5 seconds will save the settings entered & the thermostat will return to normal
operational mode.
