18
Deco 330
Adjusting Height of Embroidery Foot P
Space between the needle plate and the bottom surface of the Foot (P) should be
1.0 to 1.6 mm, when the needle bar is at its lowest position.
1 Remove the front cover unit. (See page 6)
2 Lower the needle bar and lower the presser foot lifter.
3 Insert the 1.2 mm Thickness gauge 1 between
the Embroidery Foot (P) 2 and the needle plate.
4 While pressing the Pressure bar actuator 3 down
against the upper shaft cam, loosen the Screw (A) 4
and push it down to the direction of arrow, then tighten
Screw (A) 4 again.
5 Reattach the rear cover.
1 Thickness gauge
2 Embroidery foot (P)
3 Pressure bar actuator
Screw (A)
Needle
Needle plate
3
4
2
1
5
6
5
4
6
