M
ASTERING
Y
OUR
BERNINA
®
1/04/02
artista Embroidery
/7
BERNINA
®
artisa Embroidery
M
ASTERING
Y
OUR
BERNINA
®
- grasping both inner hoop and fabric/stabilizer, insert into the outer hoop, aligning the arrows
at the edges of both the inner and outer hoops
- do not distort the fabric when tightening the screw on the hoop
- hooped fabric should be taut, but not stretched
- remove template before stitching
Attaching and Removing Hoop
Owner's manual pg.___
Adjusting Embroidery Hoop
Owner's manual pg.___
• Calibrate the needle so that it is in the exact center of the hoop
• This must be done with the large or medium hoop attached to the module
- attach module, making sure it is properly connected
- attach large or medium hoop with the template inserted
- turn
artista
on
- press the SetUp button on the
artista
- select Service
- select Adjustment of Hoop
- touch Check
-
artista
follows the contours of the hoop, stopping with the needle in the center position
- if necessary, use the positioning arrows to correct the needle position
- touch OK
- the embroidery hoop is now adjusted and the screen closes
- touch ESC to close the SetUp screen
Hoop Coding
Owner's manual pg.___
• Attach the desired hoop to module
• Raise the presser foot to the highest position (if necessary)
• Select the desired motif
- the hoop moves to read the “coding” on the hoop
• Hoop “coding” is read:
- 3 notches = large hoop
- 2 notches = medium hoop
- 1 notch = small hoop
• If the hoop is larger than the motif size, the hoop moves to the start position
• If the motif is too large for the hoop, a message will appear confirming this
- change hoops
-or-
- resize the motif in Layout, then touch Check to re-read the coding
• Icons at the left of the screen indicate the available hoops; the most suitable hoop is highlighted
