Berner BI1EG2.5B, User Manual

Page: 18 / 44

Page 17 of 44 17.07.2014
Ver. 3.3 © Berner Kochsysteme 2015
Operating
Cooking
The unit can be used immediately. If the operation indicator lamp lights and the LED shows
(1-9) continuously or flashes, energy is transferred to the pan. By turning the power control
knob, you can choose the desired power level (1-9). How much inductive power is transferred
to the pan depends to the choosed power level.
Position MINIMUM > Minimum Performance
Position MAXIMUM > Maximum Performance
Because of the following circumstances, you must pay more attention to the unit when
cooking with conventional cooking systems. If the performance step is changed with the
power control knob, the cooking material reacts immediately. Empty pans or pots heat up
very quickly. NEVER place empty pans on the glass ceramic hob. First fill the cook ware
with food, fat or liquid and then start cooking. Use the power control knob to select the exact
power level that matches the desired cooking method. The pan should always be placed in
the center of the heating zone (except devices with flächen star coil), or the pan bottom will
be heated unevenly. Check the pan continuously when heating oil or grease to prevent it
from overheating or burning.
Comfort
The induction equipment only transfers energy as long as a pan is located on the heating
zone. This is independent of the position of the power step (1-9). When you remove a pan
from the heating zone, the energy transfer to the pan is stopped immediately. When you put
the pan back in the heating zone, the energy level you have selected before is transferred
again to the pan. When turning the power control knob to the OFF position, the cooking
process is stopped. However, the equipment still stays ready for work (standby mode). To
disconnect the unit completely, you must disconnect the unit from the main supply or turn
the Main switch off (if available).
Software Version
Aufstarten des Generators
second explanation
1 8. (Test of the segments)
2 F or P (Operation Frequency or Pulse)
3 2. (Software version first digit)
4 1 (Software Version 2
nd
digit)
5 9 (Software Version third digit)
Normal use
Standby: if the performance controller is in OFF position, the point flashes all 2 seconds. If
the performance controller is in ON position, first the cook ware is searched U and the point
flashes (after 1 Minute standby modus: search pulse all 5 seconds).
If a cook ware is detected, the digital display shows the chosen performance step (1–9).
Significance of the decimal point:
ON = Normal USE
1 sec. pulse = Limitation: because to high heat sink temperature
½ sec. pulse = Limitation: because to high coil / cook ware temperature
¼ sec. pulse = Power limitation
1/10 sec. pulse = Power limitation if not optimal cook ware material
Don´t place hot cook ware on the control panels, displays or frames of the unit. To ignore
the points, follows to damages of the unit and the cookware. Consequence of ignore:
The warm cookware burning the seal material and the material get destroyed. This result
humidity and grease can penetrate in the equipment and can result in the defect of the
Equipment and raise the risk of an electric shock. Cookware will be welded together with
the surface or frame. Overheating of the displays and control surfaces leads to damages.