27
E N G L I S H
•
Only fi t 13 Amperes BS1363A approved
plugs fi tted with the correctly rated fuse
(1).
•
The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to
their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue
is for Neutral (N) (4).
•
Before replacing the top cover of the
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the
cable fi rmly and that the two leads are
correctly fi xed at the terminals crews.
WARNING: NEVER
use a light socket.
NEVER
connect the live (L) or neutral (N)
wires to the earth pin marked E or .
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable
for the power input of your charger (see technical data).
The minimum conductor size is 1 mm
2
; the maximum
length is 30 m.
When using a cable reel, always unwind the cable
completely.
Assembly and Adjustment
WARNING:
Prior to assembly and
adjustment, always remove the battery pack.
Always switch off the tool before inserting or
removing the battery pack.
WARNING:
Use only Berner battery packs
and chargers.
Inserting and Removing the Battery Pack
from the Tool (fi g. A)
1.
Insert the battery pack (11) into the grip until it
clicks in place.
2. To remove the battery pack, press the two battery
release buttons (12) simultaneously and pull the
pack out of the grip.
Fitting and Removing a Saw Blade (fi g. C)
The tool-free blade exchange system ensures quick and
easy changing of saw blades.
•
Open the blade holder (6) by fully retracting the
blade latch (4).
•
Insert the saw blade into the blade holder (6)
guiding the back of the blade into the groove of the
guide roller (7).
•
Release the blade latch (4).
•
To remove the saw blade, fully retract the blade
latch and pull the blade out of the holder.
SAW BLADES
Blade type
Applications
Fine-toothed cutting blade for smooth straight cuts
Coarse-toothed cutting
blade
for fast straight cuts
Metal cutting blade
for ferrous and non-ferrous
metals
Flush cutting blade
1)
for fi nishing off cuts up to
a wall or edge.
1)
Not available in all countries.
A wide variety of dedicated saw blades is available as
an option.
WARNING:
Always select your saw blade
with great care.
Setting the Bevel Angle (fi g. D)
The adjustable shoe (8) allows cutting of LH and RH
bevel angles up to 45°. The bevel scale has preset
positions at 0°, 15°, 30° and 45°.
•
Release the shoe lever (10).
•
Slide the shoe (8) toward the saw blade.
•
Tilt the shoe and set the desired bevel angle using
the scale.
•
Tighten the shoe lever.
Setting the Pendulum Stroke (fi g. A)
The adjustable pendulum stroke guarantees a perfect
cutting stroke for different materials.
•
Slide the selector (9) to the desired position
referring to the table below. The selector can be
manipulated during operation.
Pos.
Wood
Metal
Plastics
3
Fast cuts
–
PVC
2
Thick
workpieces
–
Fibreglass
Acrylic
1
Plywood
Aluminium
–
Chipboard
Non-ferrous
–
