Troubleshooting
Problems
Solutions
Let power switch on,when battery indicator light
on,roll speed control,the atv doesn
’
t work.
1.check whether battery fit battery case
bracket,whether battery case switch lock
well.
2.check whether fuse had fused,after the
fuse in battery case burnt,the motor will not
work,then change the same spec soluble
core will be ok.
Let power switch on,roll speed control,the atv
doesn
’
t work.
Check whether controller line is in access
mode.
Roll speed control after pause,the atv doesn
’
t
work.
Check whether parking handle is
restoration,whether it
’
s on brake
automatically de-energized
The driving speed is slower than normal
Check whether controller zipper is on
lubrication,the speed control can roll
enough,the battery is full charging.
The indicator doesn
’
t light when charging
Check whether the battery is out of power
When charging,the charger indicator lights-red
and green are all on.
Check whether the charger plug has been
connected correctly.
If above possible causes are checked ok,then there are other causes,take this ATV to authorized
dealer or the company customer service,the professional engineer will repair.
Some notes
1.Depth of discharge--the deeper of discharge, the shorter of the battery life.
2.Short of electricity-the vehicle is stored without charging after use; charging difficulties
in cold areas; poor contacts with charging circuit.
3.The lead-acid battery should be put with full charging and make sure charging monthly.
4.Over charge--charging with unmatched system,resulting battery lose excessive water
and dried up.
