11. From rear of gun, slide front handle over hoses.
12. Tape hoses together at rear of gun.
13. Slide outer jacket over hoses from rear of gun.
14. Slide outer jacket under front handle and bring front handle up
to neck, replace switch and switch housing, and secure. See
section 7-2 Changing the Switch on page 16.
15. At rear of gun, slide rear handle up over outer jacket.
16. Attach rear power block to power cable.
17. Attach gas line and water line with new clamps and crimp to
power block.
18. Slide rear handle to rear power block and secure with mounting
screws.
19. Put liner through gun and tighten.
20. Install liner. See section 7-4 Changing the Liner on page 18.
Figure 7-M
Figure 7-N
Figure 7-O
Figure 7-P
20
TG008-1.2
