6-2 Installing Gun to Quick-Connect Block
IMPORTANT: Ensure correct liner and contact tip are utilized.
Examine and replace power pin o-rings if necessary.
1. Guide welding wire into power pin.
2. Insert power pin to shoulder.
3. Tighten thumb screw securely.
4. Connect control plug lead to control housing on gun.
5. Insert control plug into feeder.
6. Securely clamp blue hose on rear housing to water-out on
water cooler and red hose on rear housing to water-in on water
cooler.
WARNING:
To prevent torch damage, it is highly advised that a
flow sensor rated at 0.5 gpm be used at all times (part # 659-
50).
7. Recheck:
a. proper gas flow;
b. drive roll pressure;
c. voltage and wire feed speed;
d. water flow (minimum 1/2 gallon per minute) at 55-65 psi.
WARNING:
Ensure water supply is on before operation.
Figure 6-C
Figure 6-D
Figure 6-E
TG408-1.2
13
Summary of Contents for T-Gun 445-45
Page 29: ...NOTES TG408 1 2 25...
