C. T Series Small Straight Handle
1. Loosen and remove locking collar.
2. Twist handle lock nut counterclockwise. Slide handle lock nut
away from handle.
3. Remove screw from handle and separate handle halves.
4. Remove switch from switch lead connectors with needle
nose pliers.
5. Connect switch lead connectors firmly onto new switch
terminals with needle nose pliers.
6. Place gun assembly into handle half, positioning neck in
desired position.
7. Fit switch into switch nest on handle (switch lead must lay
parallel).
8. Reinstall second handle half.
9. Reinstall handle lock nut and locking collar on handle.
10. Insert screw and tighten.
Figure 5-L
D. T Series Straight Handle (Switch Only)
1. Remove both housing screws with an 8 mm nut driver.
2. Ease switch out of switch housing with needle nose pliers to
grip switch.
3. Remove switch from switch lead connectors with needle
nose pliers.
4. Push switch lead connectors firmly onto new switch
terminals with needle nose pliers.
5. Depress switch housing into nest on handle (switch leads
must lay parallel).
6. Align housing holes with threaded holes in body and insert
mounting screws first before tightening with 8 mm nut driver
to even alignment.
Figure 5-M
E. C Series Straight Handle (Switch Only)
1. Remove both switch mounting screws with a Phillips
screwdriver.
2. Remove both the top and bottom pods from the handle.
3. Ease switch out of switch housing with needle nose pliers.
4. Remove switch from switch lead connectors with needle
nose pliers.
5. Push lead connectors onto new switch using needle nose
pliers.
6. Depress switch housing into nest on handle (switch leads
must lay parallel).
7. Align the holes of body housing with the holes in the handle
to start screws by hand. Finish tightening with a Phillips
screwdriver.
Figure 5-N
17
OM-BTB-2.2
