Berkley Jensen • Assembly Instructions - 3 Shelf, 3 Basket Storage Rack •
2 of 4
Tools Required For Assembly
Parts List
No tools required for assembly. A (4) top poles w/caps and pole connectors G (4) 3” wheels (2 locking)
Helpful - Rubber Mallet
B (4) poles w/pole connectors H (2) 18” side bar w/hooks
C (4) poles w/pole connectors I (29) plastic tapered lock sets
D (4) bottom poles w/ feet levelers J (4) extra plastic top pole caps
E (3) 18” x 24” standard shelves K (4) extra bottom inserts
F (3) 18” x 24” baskets 4” deep
Note: Black plastic discs used for packing only - Discard
SPECIAL WARNINGS
Assemble the item on a soft, non-abrasive surface, such as carpeting, to avoid scratching the finish.
Use care when handling. May require two adults for safe assembly.
ASSEMBLY INSTRUCTIONS
This unit may be assembled as a single 6-shelf unit or two 3-shelf units
1. Post Assembly
a. Screw pole (B) into pole (A). Hand tighten only.
b. Screw pole (C) into pole (B).
c. Screw pole (D) into pole (C).
2. Bottom Shelf Assembly (Standard Shelves or Basket Shelves)
a. Locate the desired position of the bottom shelf.
Note: Bottom shelf should be no more than six inches from the floor.
b. Insert four plastic tapered locks in the appropriate pole groove,
one in each pole. Ensure tapered end is up (see arrow on lock).
c. Place shelf on its side and slide each pole with tapered locks through
the bottom of the shelf until snug.
d. After all poles are in place, position the unit in the upright position.
e. Push down on each corner of the shelf, ensuring that the shelf is
in the fully locked position.
3. Additional Shelf Assembly (Standard Shelves or Basket Shelves)
a. Locate the desired position of the next lowest shelf and insert the tapered
locks in the poles.
b. Slide the shelf down from the top of the poles and onto the tapered locks.
Push down on each shelf corner, ensuring that the shelf is in the fully locked position.
c. Repeat for the remaining shelves.
4. Leveler Adjustment
a. Move assembled unit to the selected room location.
b. If required, adjust levelers to ensure that the unit is level.
Rotating the levelers clockwise raises the poles.
