32
Install the flush-mounting box in the correct position – horizontally or vertically aligned
– in the wall. Horizontal installation: Arrow
OBEN TOP
points upwards. Vertical in-
stallation: Arrow
OBEN TOP
points to the left. Pull bus and 230 V lines through the
appropriate bushings.
Connect mains voltage AC 230 V to terminal (7).
Connect bus line to terminal (8).
Figure 4, installation into a flush-mounting box
Install the device in flush-mounting box (17). Use enclosed screws (15).
Attach design frame (16) and press on.
If applicable, remove protective foil.
5.2 Startup
Downloading the physical address
The device must have been connected and ready for use.
Programming key (10) and LED (9) on the bottom side of the device must be accessible.
Configuration and startup with ETS2 version 1.3a or ETS3.0d.
Press programming key (10).
The programming LED is illuminated.
Assign the physical address.
The programming LED (9) ceases to be illuminated.
Note the physical address on the bottom side of the device.
GB
MT 701 CT
(16)
(15)
(14)
(17)
Summary of Contents for 7574 00
