Permanent changing of the group
o
Press group button for longer than 4 seconds.
The LED of the group flashes for approx. 4 seconds.
Desired group is active continuously.
Transmitting radio telegrams
Each channel button can be operated on the left
/\
or right
\/
.
The radio transmitter has been taught (see Commissioning chapter).
i
No telegram is sent when several buttons are pressed at the same time.
o
Press desired channel button.
Group LED lights up as long as the channel button is pressed,
Receiver responds depending on the channel button pressed and the length of the button-
press.
Channel button
Length
Lighting
Venetian blind
left
/\
less than 1 second
Switch on
Slat
adjustment
left
/\
longer than 1 second
Switch on/brighter
Blind moves up
right
\/
less than 1 second
Switch off
Slat
adjustment
right
\/
longer than 1 second
Switch off/darker
Blind moves down
i
The maximum transmitting length is 12 seconds, even if another button is pressed after
that.
Call up All On/All Off
i
During teaching of the first channel of the hand-held transmitter, the receiver learns the All
on/All off button automatically.
The manual transmitter is taught into the receiver.
o
Press the All On (2) or All Off button (3) for longer than 1 second.
The load is switched on or off on all receivers.
As an acknowledgement, all group LEDs (4) light up for approx. 12 seconds.
Change All On/All Off
If receivers do not switch to 100% brightness or switch Off when the All On or All Off button is
pressed, the brightness value can be changed for each receiver.
o
Press the All On or All Off button for at least 1 second.
All taught receivers switch On or Off.
o
Adjust the desired lighting situation for All On or All Off.
o
Press the All On or All Off button for at least 10 seconds.
First the old lighting situation is called up; do not release the button during this. After about
10 seconds the new lighting situation is activated and saved.
The three group LEDs flash as an acknowledgement.
i
If a receiver does not respond anymore to the All On or All Off button, the receiver must be
in the programming mode while changing from All On or All Off (see instructions for the
receiver).
Save light scene
The scope of a light scene includes:
- Fixed dimming value of a lighting, e.g. 70% of the maximum brightness or
- fixed switching state of a load, e.g. fan switched on or
- fixed end position of a blind, e.g blind lowered.
Light scene button (6) has been taught (see Commissioning chapter).
Seite 3/6
12.09.2011
82526111
97-09495-000
radio bus
Radio hand-held transmitter comfort
