Berkeley BPC Series, Quick Start Manual

Page: 3 / 8

MOTOR
VOLTAGE
SCREEN
The screen
shows motor voltage.
Scroll to select the
correct voltage for your
motor as stated on the
motor nameplate. This
sample shows 460 volts.
Press SAVE.
3
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM
PAR EDIT PAR EDIT
460 V 460 V
9905 MOTOR NOM VOLT 9905 MOTOR NOM VOLT
MOTOR
CURRENT
SCREEN
Enter the motor
current from the motor
nameplate (not maximum
amps). Scroll to select the
current and press SAVE.
4
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM
PAR EDIT PAR EDIT
3.8 A 3.8 A
9906 MOTOR NOM CURR 9906 MOTOR NOM CURR
MOTOR
HORSEPOWER
SCREEN
Enter the motor
horsepower (HP)
from the motor nameplate.
Scroll to select the horse-
power and press SAVE.
The sample here shows
3.0 HP.
7
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM
PAR EDIT PAR EDIT
3.0 hp 3.0 hp
9909 MOTOR NOM POWER 9909 MOTOR NOM POWER
FOR SUBMERSIBLE
PUMPS ONLY
Enter the minumum speed
allowed by the motor ven-
dor (consult motor litera-
ture). This is to prevent
motor bearing damage.
8
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM
PAR EDIT PAR EDIT
0 RPM 0 RPM
2001 MIN SPEED 2001 MIN SPEED
PID SLEEP
LEVEL SCREEN
Enter the PID sleep level.
This is a motor speed setting.
If the motor speed falls below
this RPM, the PID sleep
function will be enabled.This
is a controller-assigned
value. For additional informa-
tion, refer to the ACS550 Users Manual. Scroll to select the speed and then
press SAVE. The sample here shows 0 RPM (waiting to be set).
Burn Hazard. If the sleep level is set too low,
the pump my run without flow. This can boil water inside the pump, causing dan-
gerously high pressure and temperature.
11
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM
PAR EDIT PAR EDIT
0 rpm 0 rpm
4023 PID SLEEP LEVEL 4023 PID SLEEP LEVEL
WAKE UP
DEVIATION
SCREEN
Enter the wake-up
deviation. This is the amount
pressure drops (PSI) below
the pressure set point
before the drive restarts.
This sample is waiting to be
set and shows 0 PSI.
12
EXIT EXIT
00:00 00:00
SAVE SAVE
REM REM PAR EDIT PAR EDIT
0.0 PSI 0.0 PSI
4025 WAKE-UP DEV 4025 WAKE-UP DEV
STOP THE PUMP
Press the STOP button.
16
CHECK FOR
SYSTEM
HARMONICS
While the pump is running,
scroll motor speed up to
check for harmonics. Verify
that harmonics do not exist
above the PID sleep level.
15
CHANGE
TO REMOTE
OPERATION
Press the Loc / Rem button
to change to remote control.
LOC
REM
17
TEST
SYSTEM SETUP
Press start to operate the
pump. Test system to ensure
proper system response and
sleep function. Adjust group
40 parameters as needed.
18
3