1.
Perform zero adjustment prior to replacing index
knob.
2.
Replace index knob.
NOTE:
Ensure end of cable goes into index knob hole
within spiral groove.
Fig. 30
3.
Hold index knob at "0", and adjust index cam up
or down to achieve proper height as outlined in
GAUGE PLATE ADJUSTMENT.
Fig. 31
4.
Hold index knob in place and tighten nut to 140
in.-lbs.
5.
Perform INTERLOCK CABLES / INDEX KNOB
ADJUSTMENTS.
6.
Replace cap.
7.
Check slicer for proper operation.
BOTTOM COVER (X13A, X13AE)
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
Electrical and grounding connections must
comply with the applicable portions of the
National Electrical Code and / or other local
electrical codes.
1.
Place slicer on its side, so it is resting on motor
housing.
2.
Remove screws and unscrew foot.
Fig. 32
3.
Remove bottom cover.
4.
Reverse procedure to install.
A.
Apply Loctite® primer and Loctite® 2440™
to threads of foot.
5.
Check slicer for proper operation.
AUTODRIVE MECHANISM (X13A,
X13AE)
Autodrive Mechanism Removal
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove bottom cover as outlined under
BOTTOM COVER (X13A, X13AE).
X13 SLICER - REMOVAL AND REPLACEMENT OF PARTS
Page 15 of 36
F25332 Rev. A (0718)
