ROTARY SWITCH
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove base housing as outlined under BASE
AND TOP HOUSING.
2.
Remove wire ties as necessary.
3.
Tag and mark all wires and connectors.
4.
Remove connector from control board.
Fig. 17
5.
Turn top housing upright and support.
6.
Remove knob from rotary switch.
7.
Remove nut and rotary switch from top housing.
Fig. 18
8.
Install rotary switch in reverse order of removal.
MICROSWITCH
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove base housing as outlined under BASE
AND TOP HOUSING.
2.
Remove wire ties as necessary.
3.
Tag and mark all wires and connectors.
4.
Remove two connectors from control board.
5.
Remove two Torx screws and microswitch
bracket from top housing.
Fig. 19
6.
Remove two wires and connectors from
microswitch.
Fig. 20
7.
Remove two Torx screws, switch, and insulator
from microswitch bracket.
Food Processer - REMOVAL AND REPLACEMENT OF PARTS
F25264 (0116)
Page 8 of 13
