TROUBLESHOOTING
TROUBLESHOOTING
To eliminate the risk of damage to the motor, the CC34, B32, and C32 are fitted with thermal motor
protection that automatically switches off the machine if the temperature of the motor should become too high. The
thermal motor protection has automatic reset, which means that the machine can be started again when the motor
has cooled down, which usually takes between 10 and 30 minutes.
SYMPTOMS
POSSIBLE CAUSES
Processor will not start.
1.
No voltage, check source.
2.
Feeder or Bowl/Lid is not installed properly.
3.
Safety interlock open.
4.
Magnetic switch speed control open.
5.
Magnetic switch safety control open.
Processor starts, but stops during use. Will restart after
waiting several minutes.
1.
Check for overloaded conditions.
2.
Malfunctioning motor.
Low output or bad cutting results.
1.
Wrong cutting tools used.
2.
Wrong combination of cutting tool.
3.
Cutting tools dull.
4.
Speed control switch not in correct position.
5.
Malfunctioning motor.
Stops when operating.
1.
Safety interlock open or malfunctioning.
2.
Magnetic switch speed control open or
malfunctioning.
3.
Magnetic switch safety control open or
malfunctioning.
4.
Speed control switch malfunctioning.
Motor runs. but knife shaft does not turn.
1.
Check drive belt.
Food Processer - TROUBLESHOOTING
Page 13 of 13
F25264 (0116)
