INSTALLING THE OPTIPAC
Connecting the OptiPac Drive
OptiPac 2652MD User's Manual
7
Connecting the
OptiPac Drive
For specific installation and configuration instructions for your
computer, refer to your RTE Manager’s Manual.
These instructions are for connecting an OptiPac 2652MD model to the
Bering 2000MX MAC Disk Interface installed in the HP 1000.
s
CAUTION:
Turn off your computer and unplug the power cord from the wall outlet.
Disconnect any other cables attached to the back panel of your computer
that may be in your way.
Figure 2-2: Connecting the OptiPac
1. Turn off your computer and the OptiPac drive.
2. Connect the SCSI cable into either SCSI connector on the back panel of
the OptiPac.
3. Attach a SCSI terminator to the other SCSI connector on the back panel
of the OptiPac.
4. Plug the other end of the SCSI cable into the MX2000 card in the HP1000.
5. Connect the power cable to the back of the OptiPac. Make sure there is
at least one inch of space around the back and two inches around the
sides of the drive.
6. Plug the OptiPac and the computer into grounded electrical outlets or
a surge protector. The OptiPac should be on the same circuit as your
computer.
s
CAUTION:
Make sure that other equipment or appliances which might generate
electrical noise or a power surge (such as electric typewriters or heaters)
are on separate circuits.
7. Turn on the OptiPac, the computer, and any other peripherals.
AC receptacle
with fuse holder
and spare fuse
Power cable
SCSI cable
Connect to
computer
SCSI cable to
computer
SCSI terminator
