USER MANUAL 1.1 | B-PRIMIS ET-PRIME SERIES
Berghof Automation GmbH | Arbachtalstrasse 26 | 72800 Eningen |
B-PRIMIS_ET-PRIME_EN_1.1.docx
16
4.
Installation
4.1. Preparation for front installation ET-Prime 7
The device is intended for installation from the front into a rectangular cut-out on a panel. The
support material must be rigid and be from 1 to 3 mm thick.
Fig. 2: Dimension ET-Prime 7
Requirements:
→
To allow sufficient air circulation, it must be ensured that the device has a clear space of
at least 20 mm all round at the rear.
→
The max. ambient temperature inside the control cabinet must not exceed 55 °C in oper-
ation.
→
The support material for the installation cut-out must be flat, sufficiently stable, and be
from 1 to 3 mm thick.
