USER MANUAL 1.2 | B-NIMIS MC-PI AND BC-PI SERIES
Berghof Automation GmbH | Arbachtalstrasse 26 | 72800 Eningen | Germany | www.berghof-automation.com
32
7.2. Initial start-up of the network
This chapter applies only for the MC-Pi series!
Starting-up via the web interface
The device must be connected to the network with the correct settings before it can be used.
Upon delivery, the IP-address and network mask are set to:
IP address: 169.254.255.XX
XX corresponds to the last 2 digits of the device serial number. Exception: 00 becomes 100.
Network mask: 255.255.255.0
This setting can be used for initial setup of the device in the IP network.
NOTICE
Damage to property!
Before connecting the power supply, ensure that all cabling and the polarity of all the con-
nections are correct.
1.
Supply power to the device (24 V).
2.
Connect the device to a programming computer using a network cable (X4) and network switch.
3.
Open a web browser on the programming computer.
4.
Enter the IP address of the device into the web browser.
The login window is displayed.
Fig.: 7 Login window
5.
Log in with the following login information:
Name: admin
Password: admin
The web configuration page will be displayed.
