Press the “Time” button. A “0” will flash in the far right corner of the display panel. Press the “+” button until
you reach the desired amount of time. Examples: To program 5 minutes, press “Time” once, then press “+”
until you see 00:05 on the display. For 20 minutes, press “Time” twice, then press the “+” button until you see
00:20. For 2 hours and 30 minutes, press “Time” twice before pressing “+” until you reach 3, then press “Time”
again. Press “+” until you reach 2 (the display will show 02:30).
• The blinking “0” indicates the digit you can adjust. The maximum time is 3:00.
• The display shows hours and minutes, but not seconds.
Pause /Clear Function:
To interrupt cooking, press the “Pause/Clear” button once. This will pause the UNIT at whatever might be the
current stage. The temperature or time will remain listed in the display panel, but the “F” / “:” will be blinking.
To resume, press “Start.”
To CLEAR the cooking mode or display while the UNIT is in operation, press the “Pause/Clear” button twice.
The screen will be fully cleared, a “0” will appear and the unit will turn off.
Programming Function (Stage Cooking):
• Press the “Prog” button.
• “Pro” will appear in the display panel.
1. Input the desired set temperature, ranging from “Low” to “Max/Sear.” If you need to increase or decrease
the temperature, press the “-” or “+” buttons.
2. Press the “Time” button. 00:00 will appear on the display, then press the “-” or “+” buttons until you reach
the desired time. See above section “SETTING TIME” for detailed information on how to enter minutes and
hours.
•To add additional stages, repeat steps 1 and 2 and then press “Start” to begin your program. You may
program up to 10 stages (delay is considered a stage).
•If you need to change any part of the program, press the “Pause/Clear” button twice to start over.
Example:
In order to boil for 5 minutes before reducing to simmer for 20 minutes, press “Prog,” then press the
“Max/Sear” button. Press the “Time” button once, then press “+” until you reach 5. Press “Low” next, then
press “Time” twice, then “+” until you reach 20. Finally, press “Start.”
NOTE: Maximum programmable cook time is 3:00.
Delay Function:
The purpose of this function is to allow for set programs to start at a later time.
To delay a program, press “Prog,” then press the “Time” button. A “0” will flash in the lower right corner of the
display panel. Press the “+” button until the desired amount of time you wish to delay the program start is
reached (for more information, review SETTING TIME on the top of this page). Then press “Prog” again to set
cooking program. The amount of time selected for delay is included in the programmed stages. To continue to
the next stage, press “Low” to “Max /Sear” to set the cooking temperature. Continue with step #2 from the
“PROGRAMMING FUNCTION” instructions. Once ready for the countdown to begin, press “Start.” When delay
countdown reaches “0,” the UNIT will beep once to signal the end. At this point, the cooking time will start and
the temperature will be displayed.
• The maximum time for delay function is 99 hours and 59 minutes.
Lock:
•Long press “+” and “-“ together for 2 seconds, the cooktop enter “lock” mode and the display will show “-LOC”.
While locked, the cooktop will not respond to temperature and time change. The only button will function is
the Pause/Clear button, to allow you to stop cooking in case of any emergency.
•To turn the child lock off, long press “+” and “-“together for 2 seconds.
