7
HOT WATER BURNER START PROCEDURE
1. Fill the black fuel tank with Diesel or Kerosene (No.1 or No.2 grade)
2. The battery must be plugged in and fully charged to start the heater.
2. Once the engine is running, push the burner toggle switch to the ON position and
adjust the thermostat to the desired temperature.
NOTICE
Once the heater has been started, the water will begin heating up in about 20 seconds. It will
reach maximum temperature within 2.5 minutes of continuous spraying through the gun. The
burner will not fire when the trigger is released.
HOT WATER BURNER START AND STOP PROCEDURE
HOT WATER BURNER STOP PROCEDURE
1. To turn off, push the burner toggle switch to the OFF posistion.
2. Once the heater is off,
squeeze the trigger and discharge the water for three minutes to
cool the heat exchanger and high pressure hose. Insufficient cool-down periods for the high
pressure hose will cause excessive wear and eventual rupture of the hose.
WARNING
The water temperature can become extremely hot during operation.
Use caution when operating the spray gun.
ON/OFF
Toggle Switch
TACH/HOUR Meter
Thermostat