Beper URC8805, Use Instructions

Page: 14 / 44

14
LEARN FUNCTION OPERATION GUIDE
After setup, if you think it’s not convenient for you to use your remote and your original
remote still can use.
You can use learning function to copy the codes of your original remote to our URC8805
remote. You can learn the codes to any key that you like.
LEARN the code into you remote control
1. Press once the device button such as [TV], the device button will blink once. Press
and hold the [LEARN] button and keep about 3 seconds. The device button will light
up.
2. Now push the original remote control and your URC8805 infrared window opposite,
and keep within 5cm space.
3. Press the button that you want to learn on the original remote control, the device
button will blink incessant and learning succeeds..
4. Press the button that you want to learn on you URC8805, the LED stop blink and
keep light up and learning succeed. If LED blinks twice and leaves learning mode, it
means the memory is not enough. You need to delete some learned keys then learning
again.
5. Repeat steps 3 to 4 above and learn all buttons of current device you wish to learn
in your remote control.
6. Then press [LERAN] button (or no any operation in 20 seconds) to save and go out
LEARN mode, and the device button will light off.
7. Repeat 1-6 above to learn all device and all buttons that you want to learn in your
remote control.
NOTE:
In URC8805, these keys can not be learned: all device button, MACRO, LEARN and
TV/AV button.
CLEAR the Learned Code in Your Remote Control
CLEAR ONE BUTTON
1. Press and hold the device button where the button you want to clear, then press and
hold the [POWER] button at the same time, until the button led light up then release
both buttons.
2. Entry the operation code [9990].
3. Then press the button that you want to clear, the led will slowly blink twice and clear
finished. If the led quickly blink twice, the means this button not be learned.
4. Repeat step 3 above to clear other is learned button if you want.
CLEAR one device
1. Press and hold the device button where the button you want to clear, then press and
hold the [POWER] button at the same time, until the button led light up then release
both buttons.
2. Entry the operation code [9991].
3. Then all learned button will be cleared, the led will slowly blink twice and go out.
CLEAR all devices
1. Press and hold the any device button on your remote control, then press and hold
the [POWER] button at the same time, until the button led light up then release both
buttons.
2. Entry the operation code [9995].
3. Then all learned button all device will be cleared, the led will slowly blink twice and
go out.