8
EN
Charging
Before first use, it is better to fully charge the device. Insert the USB
cable inside the connector, and connect the massager to a charging
device (powerbank, laptop, etc.) or to a USB adapter (not included).
The LED indicator’s blue light will flash during charging, and it will
stay on when charging is complete.
Disconnect the USB cable from the massager once charging is
completed.
If the LED indicator flashes during operation of the device, this me-
ans the battery is running out; proceed to charge it as described
above.
Operation
Before use, it is better to slightly wet the skin on the neck area (with
warm water or water-based gel or cream), to ensure the perfect
adhesion of the electrodes to the skin, and to avoid rashes.
Press the ON/OFF key for a few seconds to activate the device.
The device is equipped with a guide voice that will indicate selected
mode and intensity level.
When switched on, the device will start operating in auto mode: the
blue LED indicator is on, and the guide voice states “Mode 1” (mode
one); the device operates combining all other 5 massage modes
available, alternating them in cycles of 1 minute.
By pressing the ON/OFF key, it is possible to select the desired
massage mode, the guide voice will state the selected mode (Mode
1 – mode one, Mode 2 – mode two, Mode 3 – mode three, Mode
4 – mode four, Mode 5 – mode five, Mode 6 – mode six)
Mode
2
Mode 3
Mode
4
Mode
5
Mode
6
Pulse
width
100µs
100µs
500µs
500µs
500µs
Pulse
frequency
50Hz
40Hz
10Hz
25Hz
100Hz
On-Time
20s
10s/2*
10s
4s
6s/2*
Off-Time
2s
2/10s**
1s
0,5s
5/4s**