Table air cooler Use Instructions
8
Description of the item fig.A
1. Switch button
2. Rear grill
3. Usb cable connector
4. Water tank
5. Light selection button
6. Speed selection button
7. Speed indicator
8. Front grill
9. Usb cable
Use
After placing the product on a flat and stable surface, open the water tank door and fill it using a measuring cup
or jar. (It is recommended not to let the water overflow).
Connect the smallest part of the usb cable to the appropriate plug located at the bottom of the rear grille, and the
larger part of the usb cable to a computer or other source of charge.
It is also possible to connect the widest part of the usb cable to an adapter to connect it then to the power outlet.
Press the switch button and set the desired speed by pressing the appropriate button. It is possible to choose
between three types of speed (low, medium, high), the indicator light next to the button indicates the selected
speed.
It is also possible to choose whether to operate the product with light and optionally choose from 7 different co-
lours using the appropriate button. You can choose a fixed colour from those proposed or the colour cycle mode
by pressing the colour selection button 8 times.
When finished, press the switch button to turn off the product.
Cleaning and care
Make sure the product is turned off and unplugged from the power cord before performing any cleaning and / or
maintenance operation.
Clean the water tank and the outside of the product with a soft, slightly damp cloth.
To maintain product performance over time, it is recommended to replace the evaporative panel every 6 months.
To replace the evaporative panel proceed as follows:
Gently press the grid release tab placed on the bottom of the front grille and pull the grille towards yourself.
Remove the used evaporative panel and replace it with the new one.
Reposition the front grille, being careful to hook it correctly.
Technical data
Input: dc 5v - usb
For any improvement reasons, beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
