Rechargeable Vacuum Cleaner with foldable tube Use instructions
10
Once a single line of the battery level indicator flashes, turn off the product and connect the electric plug of the
battery charger to a power outlet and the plug into the socket on the side of the battery.
The three charging lines will light up in sequence and the red light placed near the plug connection on the battery
will flash.
At the end of the recharge, the three lines will all be illuminated and the light near the attack will be blue and not
flashing.
Full recharge in 4 hours – 25 minutes working time in high speed – 35 minutes working time in low speed.
The battery can be recharged either attached to the handle or detached from it. To detach the battery from the
handle, press the battery release button and remove it (Fig.B).
To reposition the battery under the handle, insert the battery into the grooves until you hear a click.
The appliance works in two different ways
As a stick vacuum cleaner simply using the tube and its accessories
As a handheld vacuum cleaner simply using the accessories without the tube
Instructions for use
Connect the handle to the dust tank by aligning the arrow ↓ placed on the lower part of the motor, to the
symbol and by holding the tank turn the handle clockwise until you hear a click and the arrow ↓ is aligned to
the symbol
Connect the metallic tube (or the chosen accessory) to the dust tank until you hear a click (Fig.C). To insert the
motorized brush, connect it to the metallic tube or directly to the dust tank (Fig.D).
The motorized brush is suitable for cleaning any type of surface and carpets with short and medium bristles.
It is possible to connect the nozzle with brushes and the crevice nozzle to the dust tank or the metallic tube
(Fig.E).
The nozzle with brushes can be used to clean surfaces and worktops, but also sofas and fabrics.
The crevice nozzle is suitable for cleaning corners, cracks or areas hard to reach.
To disconnect the metallic tube or the accessories press the metal tube release button.
To turn on the appliance press the switch, to turn it off press the switch again.
With the +/- button placed on the handle is possible to regulate the speed.
Warning: immediately turn off the product if something gets stuck inside the suction accessory.
Cleaning
Do not use water, solvents or polishes to clean the exterior of the product, only use a dry cloth. Make sure that
no liquid enters the appliance. Do not immerse the product in water and do not clean it in dishwasher.
Caution clean the dust tank and the filter after each use; the suction power will be reduced if the
tank is full and / or the filter is clogged.
To empty the dust tank press the opener button, to close it replace the lid until you hear a click (Fig.F).
Press the handle release button to disconnect it from the dust tank and rotate the tank clockwise until the arrow
↓ is aligned to the symbol and extract it (Fig.G).
Remove the tissue filter and the filter cover (Fig.H) and wash them in water. Let them completely dry at the air
before reassemble them. The tissue filter must be repositioned with the tab facing up .
Be sure the filter and all parts are well positioned before reconnect the dust tank to the main body.
How to clean the motorized brush
Caution clean the brush only after removing it from the appliance.
Turn the brush upside down to have the bristles facing up, push the lever on the left of the brush downwards,
moving it towards the symbol . In this way the cylinder with the bristles is raised and it is possible to remove
it. Wash it with water and allow to dry completely. To reinsert the cylinder, insert the round end into the right side
of the brush and press the left side down until you hear a click.
