Beper 50.161, Use Instructions, Page: 12 / 52

12
Cordless iron Use instructions
STEAM IRONING:
While heating, set the steam button to zero «0»
Position the iron in a vertical position and set the temperature control to minimum.
Insert the plug into the wall socket, then turn the temperature control to maximum. The temperature control light
will switch on, indicating that the iron is heating up.
When the light switch off, the set temperature has been reached and the iron is ready for use.
During ironing, the light will turn on and off automatically as the thermostat maintains the set temperature (it is
still possible to continue ironing during this process).
Select the desired amount of steam, using the appropriate button. It is possible to choose between three diffe-
rent types of intensity (zero, one, two), the choice made is visible on the display placed in front of the spray and
steam shot buttons.
The steam is produced as soon as the iron is held in a horizontal position.
CAUTION: Take care not to come into contact with the expelled steam. Do not direct the steam jet to-
wards people and / or animals.
WARNING: If the water in the tank runs out during use, wait until the iron has cooled down before filling
it again.
WARNING: Before using the steam, wait until the temperature has been reached, otherwise the plate may
drip because the steam is not yet ready.
SPRAY
As long as there is enough water in the water tank, you can use the “Spray” button regardless of the set tempe-
rature, and that ironing steam or dry.
When using the iron for the first time, it is advisable to press the “Spray” button few times before obtaining an
adequate spray, as the water must be able to fill the circulation pipes before exiting.
STEAM SHOT:
The steam shot is used to remove the most stubborn creases.
Set the thermostat knob to the position “●●” or “●●●”.
Set the steam setting button to the maximum position (two)
Press the steam shot button.
NOTE: To avoid water leaking from the plate, do not hold the steam shot button for more than 5 seconds
continuously.
DRY IRONING:
The steam iron can also be used dry with or without water in the water tank. However, it would be better to avoid
filling the water tank while ironing.
Set the steam control button to the minimum position (zero).
Set the temperature control to the most suitable temperature for the fabric to be ironed.
SELF CLEAN (AUTO-CLEANING)
Fill half of the water tank.
Set the temperature control to the maximum position and the steam setting button to the minimum position.
Plug the power cord into the wall socket.
Let the iron warm up until the light switches off.
Holding the iron in a horizontal position above the sink, place the steam selector in the maximum position, press
5 times the “Self Clean” button.
The boiling water, the steam and the impurities will be expelled from the holes in the plate.
Unplug the power cord from the power outlet.
Wait until the iron is cold before storing it.
ANTI-CALC SYSTEM
A special resin filter inside the water tank softens the water and prevents limescale build-up in the plate. The
resin filter is permanent and does not require replacement.
Note:
Do not use chemical additives, scented substances or descaling agents. Failure to comply with the abo-
ve mentioned regulations will make a loss of the warranty.