9
USB Hair Straightener Use instructions
EN
Description of the product: Fig.1
1. Charging cable
2. Cable inlet
3. ON/OFF button
4. Charging light
5. Temperature selection light (160°-180°-200°C)
6. Lock button
7. Unlock button
Some warnings:
1. Only use the appliance for the purpose of styling the hair.
2. When the appliance is charging , please make sure the lock is in place.
3. When charging, keep the USB cable away from the water and possible splashes of water (sink,
baths…. )
4. Never wing the USB cable around the appliance while charging or in use.
5. While using and/or charging keep the appliance out of reach of children as it may cause burns
or injuries.
6. Always make sure the switch is turned at OFF and power OFF after use.
7. Leave the appliance to cool down after turning it off before putting it in the pocket bag.
8. Keep hands only at handle and not at the clamps or heating plates in order not to burns or injuries.
Use of the appliance:
The default set temperature is 180 ° C.
Charge the product using the appropriate cable. The charging time is about 3-4 hours.
Press the ON/OFF button for few seconds until the charging light comes on and the temperature
selection light flashes at 180 ° (default set temperature).
Use the ON/OFF button to set the desired temperature (160-180-200° C).
When the temperature selection light stops flashing it means that the temperature has been reached
and the plate is ready for use.
After use the product, press the ON/OFF button for a few seconds and the product will switch off.
When the battery of the product is charged the charging light is green, when the battery is quite
finish the charging light will flash red for 5 seconds and then switch off automatically.
If the temperature selection lights flash at the same time, it means that the product has a problem
and you need to contact the assistance.
The product is equipped with an auto-shutoff system that activates after 15 minutes.
During charging the charging light is red, it will turn green when the battery is fully charged.
CLEANING AND MAINTENANCE:
Before cleaning the product, make sure it is turned off and has cooled down.
Use a soft, slightly damp cloth to clean the plates and the outer surface than dry thoroughly.
Do not use chemicals, abrasives or solvents.
Do not immerse in water and prevent any kind of liquid from entering the product.
