Beper 40.330, Use Instructions

Page: 11 / 40

11
EN
Man Body Groomer Use Instructions
Otherwise, not need to apply any regulator.
For dry use, make sure the skin is clean and dry before using the product.
For use with wet skin, you can treat the skin with soap or shaving foam before using the product.
For better shaving result and to minimize shaving head wear, make sure that product is in total contact with the
skin, without pressing too much as excessive pressure can cause skin irritation.
Set the power button to ON.
Start moving the product with slow and delicate movements, making sure that the shaving direction is opposite
to the hair growth. With your free hand stretch the skin so that it will be smoother.
Caution: Not all hairs grow in the same direction, so you may need to change the direction of use several times
while using the appliance.
Turn off the product by setting the button on OFF.
USE OF THE BACK SHAVING EXTENSION:
Press the unlock button placed at the side of the extension and fully open the extension until you hear a slight
click.
Open the hook: To open the hook press with the thumb in the direction of the arrow and lift.
Place the product in the appropriate housing at the top of the extension.
Fix the product by closing the hook.
Turn on the product and proceed with shaving/trimming.
To close the extension press the button placed on the side and close it on itself.
CLEANING AND MAINTENANCE:
The product must be cleaned immediately after each use.
Always turn off the product and make sure the power cord is disconnected before starting any cleaning operation.
Do not use compressed air, abrasive cleaners, wipes or aggressive liquids such as gasoline, alcohol, bleach or
acetone to clean the appliance.
Do not clean, remove, or replace the shaving head while the product being switched on.
Do not apply any pressure on the shaving head.
Use only the supplied cleaning brush. Any other brush can cause damage.
Clean the shaving head:
When the product is off and disconnected from the power supply, remove any trimming combs, pull the shaving
head out to remove it.
Rinse the shaving head under warm running tap water.
Clean the shaving head housing with the cleaning brush or rinse it under warm running tap water.
Do not use cloths, towels to dry these parts, but let them dry in the air.
Once the product is dry, reattach the shaving head in its housing.
Wipe the rest of the product with a slightly moistened soft cloth or rinse with warm running water and take care
to dry it immediately.
Replace the shaving head:
If the shaving head is damaged or worn, it is recommended not to use the product and immediately replace it.
It is suggested to replace the shaving head at least once a year.
Caution: When handling the shaving head, be careful because it is sharp and you may be injured.
Before storing the product make sure it is clean and dry.
TECHNICAL DATA:
Power supply:
Input: 100-240V ~ 50 / 60Hz – 0.2A
Output: 5.0V -1000mAh
Product:
Lithium battery 3.7V
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.