7 INSTRUCTION MANUAL
DESCRIPTION OF THE DEVICE
1.
2.
3.
4.
5.
Stand
Instrument case
Filter mesh
Lid open button
Power «on/off» button
BEFORE FIRST USE
•
Before switching on the kettle, make sure that the voltage indicated on the appliance
corresponds to the mains voltage.
•
Fill the kettle with cold water to the maximum mark, close the lid tightly, place the kettle on the
base, then connect the power cord to the power outlet, and the indicator light will light up
when boiling water.
•
Make sure that the lid is tightly closed when boiling water, otherwise the automatic shutdown
system will not work when boiling.
•
To prevent water from pouring over the edges of the tank during boiling, do not fill the kettle’s
tank with water above the maximum level. To prevent damage to the heating element, do not
boil water in the kettle if the water level is below the minimum mark.
•
Do not remove the kettle from the stand while boiling, wait until the appliance switches off.
•
After the device is turned off automatically, the kettle can be turned on to re-boil water after
15– 20 seconds.
OPERATION OF THE DEVICE
Place the stand on a dry, solid, horizontal surface.
Fill the kettle with the required amount of water. Check the water level on the scale on the
kettle body. Make sure that the water level is between the minimum and maximum level.
The amount of water less than 0.5 liters (to the minimum level) may cause the water to boil
out, heat the empty kettle and break it.
Water exceeding the maximum level (2 L) will be spilled when boiling.
Make sure that the kettle lid is properly and tightly closed, otherwise the kettle will not
automatically turn off.
Put the kettle on the stand. The base of the kettle should fit exactly on the stand.
Insert the plug into a grounded outlet.
Turn the "O/I" switch to the "I" position, after which the appliance lights up and the heating
starts. Do not touch any part of the kettle that is on, other than the handle.
When the water boils, the light on the appliance will go out and the kettle will automatically
turn off. The "O/I" switch will automatically return to the "O" position. The kettle can also be
turned off manually by switching The switch "O/I" to the "O" position.
Remove the kettle from the stand and carefully pour water into the cups. The kettle must be
turned off.
ATTENTION! Your kettle is equipped with an overheat protection system. If there is no or little
water in the kettle, it will automatically turn off when it overheats. If this happens, you must
wait at least half an hour for the kettle to cool down, after which you can pour water.
