EN
Dear customer!
We thank you for the choice made in favor of the home appliances brand BEON
.
6 INSTRUCTION MANUAL
The electric kettle is intended only for heating or boiling water at home indoors and must be
used strictly for its intended purpose. The device is not intended for outdoor use.
SAFETY INSTRUCTIONS AND WARNINGS
Do not use the kettle for industrial or commercial purposes.
Observe the following safety measures when using the kettle:
Make sure that the voltage indicated on the bottom of the kettle matches the mains voltage.
The kettle must be grounded. In the event of any short-circuit, grounding reduces the risk of
electric shock, since the current will be diverted through the grounded wire. This device uses a
ground network wire and a plug with a ground contact. The plug is connected to an outlet that
must be installed and grounded appropriately.
The outlet must be located in close proximity to the kettle so that the kettle can be
immediately disconnected from the power supply if necessary.
If you need to use an extension cord, make sure that it is designed for the power consumption
of the device. When using an extension cable, make sure that the ground wire of the extension
cable is securely connected to the ground contacts at both ends of the wire.
Do not use adapters when connecting the device to the electrical network.
For additional protection in the power supply chain, it is advisable to install a protective
disconnection device (RCD) with a nominal tripping current not exceeding 30 mA. For correct
installation of the RCD, contact a specialist.
Make sure that the electric cord does not twist or bend, or come into contact with sharp
objects, corners and edges of furniture, or hot surfaces, including the outside of the kettle
itself. Do not damage the insulation of the power cord.
Do not pull the power cord when disconnecting from the power supply. Hold the plug (the
isolated part).
To avoid electric shock, do not use the device in areas with high humidity, near sources of
moisture and water containers (for example, in the bathroom, in the vicinity of the kitchen sink,
in damp basements, near a pond or pool, etc.).
Avoid getting wet on the contact group of the kettle, the power cord or plug, and on the lower
part of the kettle body.
Do not put the kettle, stand, cord, or plug in water or any other liquid.
Do not turn on the kettle if the cord or plug is damaged, the appliance has fallen on the floor or
has any other damage. Contact an authorized service center for solving the problem.
Place the kettle on a flat, stable surface.
Do not allow the power cord to hang over the edge of the table. Children or pets may pull the
cord and tip over the kettle with hot water.
Do not install the kettle near a heat source (such as an electric stove or an open fire).
Do not install the kettle under a fabric canopy or low-hanging wall cabinets.
Use an additional stand if you are installing the kettle on wooden surfaces to protect the
furniture covering from damage.
Do not turn on the kettle if there is no water in it or the water level is below the minimum level.
