13
START UP
6 Operation
6.1 Noise
The range of product satisfies a noise (sound pressure level) of 85 dB(A) or less when measured at 1 meter from the
unit surface. Measurements taken in accordance with ISO 8579-1:2002.
6.2 General Safety
Potential hazards which can be encountered during installation, maintenance and operation of drives is covered in
greater detail in the product safety page at the front of this booklet. (See chapter 1 Information).
Advice is also given on sensible precautions which need to be taken to avoid injury or damage. Please read!
6.3 Initial start up for gear units operating in a potentially explosive atmosphere
After 3 hours of operation check the gear unit surface temperature. This temperature should not exceed 110 degrees.
If temperature exceeds this limit, shut down immediately and contact your local sales office.
Hot surfaces!
The gear unit becomes very hot during operation. Use protective gloves.
Summary of Contents for BS 40
