Assembly
21
41
60
62
22
28
38
20
35
01
43
18
46
58
59
16
Stage A.
1). Lay the Rear Stabiliser (20) flat on the floor and lay the Base Frame U Bracket (22) onto the centre of the Rear Stabiliser,
making sure the loop is facing the rear of the gym. Place the 2 Weight Guide Tubes (21) into the 2 outer holes in the U Bracket.
2). Connect the Main Base (1) and the Rear Stabiliser together using 2 x M10 x 60mm Hex Bolts (28), 4 x M10 Flat Washers
(38) and 2 x M10 Nylon Locknuts (35).
3). Lay the Footplate (18) onto the front of the Main Base and lock in position with the Footplate Lock Pin (43).
4). Slide the 2 Rubber Bumpers (62) onto the Weight Guide Tubes followed by the 6 Weight Plates (60).
5). Take the Selector Shaft (16) and fit the Selector Shaft Bush (58) and Selector Shaft Pin (46) as per inset "A". Slide the Top
Plate (59) onto the Weight Guid Tubes and locate the Selector Shaft in position, setting the Top Plate onto the top Weight
Plate. Use the Weight Selector Pin (41) to select the desire weight.
Tip: To lock the weight stack simply place the Weight Selector Pin (41) into the welded bracket on the top of the Base
Frame U Bracket (22) which will lock the Selector Shaft (16).
Please note that as part of our production checking and for your convenience, all tube caps where necessary have been
fitted in the pre-packing stage.
Carefully unpack each component, checking against the parts list that
you have all the necessary parts to complete the assembly of your gym.
Please note that some of the parts may be pre-fitted to major
components, so please check carefully before contacting our
CUSTOMER SUPPORT team.
In any event, please do not return the product to your retailer before
contacting us first.
Tel:- 0800 3 101 202 or
+44 (0) 1535 637711
Email:- [email protected]
CUSTOMER SUPPORT is open from 9.00am to 5.00pm from Monday to Friday
e
Do NOT FULLY TIGHTEN any
Bolts, Nuts or Fittings at this
stage unless specifically
instructed to do so.
Note
X
Please ensure when finally tightening
all Bolts that the locking ring in the
Locknut is fully engaged as (2) below.
(2)
(1)
Beny Sports Co. UK Ltd.
Unit 8 Riparian Way,
The Crossings Business Park,
Cross Hills,
West Yorkshire.
BD20 7BW
Page
1
3