Trouble Shooting
Problem
Indication
Possible Cause
Solution
Charger
does not
work
Indicator
lights are not
on
a) Charger is not plugged in
b) Poor electrical
connection
c) AC outlet is dead
a) plug in
b) Check AC connections and make
sure mains is switched on
c) Check receptacle
Charger
has no
DC output
Flashing
a) Battery is connected with
reverse polarity poles
b) Poor contact from charger to battery
c) MODE button is not
pressed
d) Charging is interrupted in
Phase1
e) Charging is interrupted in
Phase 2
f) Charging is interrupted in
Phase 5
a) Check DC connection between
charger and battery and make sure
they are not short
circuited
b) Check if connectors are not greasy
or corroded and making a clean
connection and there are no loose
or damaged connection
c) Select MODE
d) Battery is extremely sulphated, it
must be replaced
e) Battery cannot accept charge, it must be
replaced
f) Battery cannot retain charge, it
must be replaced
No
charging
current
a) Battery may be
defective / excessive
current draw
b) Battery may be severely
sulfated
a) Dead battery, it should be
replaced
b) If battery cannot be de-sulfated, it
must be replaced
No
charging
Phases
Flashing
Charger is not connected to battery over
2 mins
Charger is in energy save mode
For
ICEMAN 5.0 BLE
(Bluetooth Description)
Battery Charging Manager
Manual
1.
Connect charger to MAINS. Make sure unit is powered on. Control
panel “Power LED” lights should be on at this stage.
2.
Turn on Bluetooth on desired hand held device or laptop.
3.
Open Benton “Battery Charging Manager” Apps and press “select”
language and set desired language option. There are 15 different
languages to choose from.
4.
Select Benton Battery Charger Model connected to battery to be
charged. There are several model options.
5.
Once Apps detects model being used to charge battery, it will show
process status
6.
If there exists any problem with the connection of the charger to
the battery, (reverse polarity), or if the battery is beyond
recovery, (dead battery), an ERROR message will appear to indicate
situation.
7.
After ERROR message has been dealt with and there is no issue
preventing the charging process, the monitor will show the active
process.
8.
Choose “Motorcycle” or “Car Mode”.
9.
You may also choose “Cold” mode for cold environment or “Boost” mode
for depleted battery.
10.
You may opt to input ON/OFF command to stop charging or to
proceed with charging process.