128
Spring Catch
129
Terminal board
n
Choosing a Mounting Location
+
Mount the Receiver and Wireless Devices after the
placement tests.
Choose a place that is:
Ø
Dry
Ø
Central to the proposed placement of all Wireless
Devices
Ø
As close to the ceiling as possible
Ø
Far from sources of interference such as: electrical
noise (computers, televisions, electric motors in ap-
pliances, and heating and air-conditioning units), and
large metal objects (heating ducts and plumbing)
which may shield the antennas.
Ensure that no electrical wires run over the Receiver
antennas. When mounting in a basement, place the
module as high and as close to the underside of the first
floor as possible. The range of the Receiver will be re-
duced if the unit is mounted below ground level.
n
Mounting the Receiver
When choosing the mounting location ensure that the
mounting surface is flat, as uneven surfaces may impair
proper functioning of the snatch switch
20
.
Read the following instructions carefully before mount-
ing the Receiver (refer to the Figure 60).
1.
Loosen the screws
22
(it is not necessary to re-
move them).
2.
Press down on the tab
24
to release the backplate
from the frontplate.
3.
Lift the frontplate upwards to a 90° angle, then pull
the frontplate away from the backplate.
4.
Pull the connection wires through the wire entry
23
.
5.
Place the backplate in the proposed placement, mark
the screw positions
17
then drill the screw holes.
!
Be careful to avoid conduits and plumbing
when drilling.
6.
Place the backplate in the proposed placement, pull
the wires through the wire entry
23
, then secure the
backplate to the wall (use anchor screws).
7.
Complete the connections on the terminal board
25
(refer to “Connecting the Receiver”).
8.
Push the frontplate spring catches into the slots on
the backplate then push the bottom of the frontplate
into place.
9.
Fasten the screws
22
.
n
Connecting the Receiver
Connect the Receiver terminal
25
to the Interface termi-
nal
15
(as shown in Figure 61).
+
Use Shielded cable for the connection: connect
one end of the shield to terminal
BLK
on the Inter-
face, and leave the other end free. Do not use more
than 50 metres total wire length.
n
Technical Specifications
The following table contains the technical Specifica-
tions of the VectorRX Receiver.
Voltage
13.8 V
_
Current draw
50 mA
Frequency
433 MHz
Dimensions (W x H x D)
146 x 290 x 28 mm
Weight
483 g
Reset default
To reset the factory default programming:
KYO 300-KYO100
APPENDIX
95
NO WIRING
IN THIS
AREA
RED BLK YEL GRN
ATN1
GND11
GND1
ATN1
GND22
GND2
®
121
125
124
123
123
122
129
121
120
120
121
126
127
128
126
122
Figure 60
The Receiver components