Installation and Operating Instructions - 1000V BUSS, Grounded (125A to 400A)
950-003342-000 Rev B
29
Chapter 3: Installation Procedure
Cutouts in the sides or back of the enclosure must be carefully determined to
avoid conflicts with the internal parts, vent, fan, and cables. Cutouts in the sides
should be limited to the areas shown in
. The cutouts at the top may be
used to bring in the AC power and Ethernet connector. The rear of the enclosure
may be used for cutouts for cables as well as the AC power and Ethernet
connectors (
).
Figure 11
Cutout locations in the sides of the BUSS
Left side
Right side
Cutout areas
Cutout areas