BENRUBI Izzy SK-100, Instruction Manual

Page: 17 / 19

16
Tips for better results:
• For very short cuts (stubble look), use the cutting guide 3mm.
• For best results, move the device against the direction of hair growth. Since all hair does
not grow in the same direction, you need to move the device in different directions
(upward, downward or across).
• Ensure that the flat part of the cutting guide is in full contact with the scalp to achieve a
consistent result.
• Make overlapping passes over the head to ensure that you cut all hair that needs to be
cut.
• To achieve a good result on curly, sparse or long hair, use a comb to guide the hair
towards the device.
Nose/Ear/Eyebrow Trimmer
1. Wash your nose before using the appliance with the nose/ear trimmer/eyebrow (5).
2. Place the nose/ear/eyebrow trimmer (5) to the body of the appliance.
3. Insert the nose/ear/eyebrow trimmer into your nose or in your ear (not more than 0.5 cm.).
4. Press the on/off button (2). The indication light (1) will turn green.
5. Move the trimmer in your nose or in your ear for better results.
6. Once you finished, press again the on/off button (1). The indication light (1) will turn off.
7. Clean the nose/ear/eyebrow trimmer and the device before storing it (see "Cleaning and
care").
Cleaning & Care
Make sure the appliance is switched off before cleaning.
After each use:
• Brush the residues from hair.
• Cleaning should be done only with a soft brush, such as the one is provided in the packaging
of the device.
• Put 2-3 drops of the lubricating oil to the trimmer.
• Do not use abrasive or corrosive cleaners for cleaning the body of the device and accessories.
• Never use compressed air to clean the cutting heads and cutting guides.
Shaving head
• Press the button (Fig.5) and clean with the brush (10).
• Rinse the head under lukewarm water. Leave the head open to dry well.
• Dry thoroughly before storage or before the next use.
Trimmer
• Remove the blades (Fig.6) and clean with the brush (10).
• Rinse the blades and the base of the head under lukewarm water. Allow to dry separately.
• Dry thoroughly before assembly, storage or before the next use.