Hardware Installation
Step 1: Remove the wireless USB mini receiver for further installation on the USB
port of PC or NB.
Step 2: With your computer turned on, plug the wireless USB mini receiver into an
available USB port on your computer.
Step 3: The system will automatically detect the new hardware and install the device
ready for use.
Step 4: Proceed to
Establishing a Wireless Connection
to complete the installation.
Establishing a Wireless Connection
Once the wireless USB mini receiver is connected to your PC,
a wireless connection will need to be established between it
and the mouse. Please perform the following steps in order to
establish a proper wireless connection:
Step 1: Be sure to raise the mouse cover to an arch as
illustrated for
Power-On
status.
Step 2: Ensure the mouse and wireless USB mini receiver are
set up as described in
Battery Installation
and
Hardware Installation
.
Step 3: To begin activation, first press the
CONNECT
button
on the wireless USB mini receiver, then press the
CONNECT
button located on mouse base.
NOTE:
1. To ensure correct operation, please make sure that the wireless USB mini receiver
is properly installed at least 20 cm (8 inches) away from electromagnetic devices
such as monitors or speakers . Also please make sure that the wireless USB mini
receiver is installed at least no more than 1 meter away from the mouse.
2. If the mouse does not activate, please repeat Step 2 and 3.
3. It is also necessary to repeat Step 2 and 3 after any loss of power from battery
replacement.
Multiple Power-Saving Modes
‧
Lower the mouse upper cover for Power-Off status or idle
time while away or absent from desktop job for a while, so
that there is no more power loss.
‧
The mouse can be manually set to sleep mode by
simultaneously pressing all three buttons (both the Left and
Right mouse buttons and the Scroll Wheel button at the