Operation
34
• The input signal type effects the options available for the Picture Mode.
See
"Selecting a picture mode" on page 36
for details.
For best display picture results, you should select and use an input signal
which outputs at this resolution. Any other resolutions will be scaled by
the projector depending upon the 'aspect ratio' setting, which may cause
some image distortion or loss of picture clarity. See
for details.
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the
projector's HDMI input and the projected picture displays wrong colors, please
change the color space to YUV.
1.
Press
MENU/EXIT
and then press
/
until the
SOURCE
menu is
highlighted.
2.
Press to highlight
Color Space Conversion
and press
/
to select a
suitable color space.
This function is only available when the HDMI input port is in use.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
• Using the remote control
1.
Press
Digital Zoom +/-
to display the
Zoom bar.
2.
Press
Digital Zoom +
to magnify the
center of the picture. Press the key
repeatedly until the picture size is suitable
for your need.
3.
Use the directional arrows ( , ,
,
)
on the projector or remote control to
navigate the picture.
4.
To restore the picture to its original size,
press
AUTO
. You can also press
Digital Zoom -
. When the key is pressed
again, the picture is further reduced until it is restored to the original size.
• Using the OSD menu
1.
Press
MENU/EXIT
and then press
/ until the
DISPLAY
menu is
highlighted.
2.
Press
to highlight
Digital Zoom
and press
MODE/ENTER
. The Zoom bar
displays.
3.
Repeat steps 2-4 in the section of
above. Or if you
are using the projector control panel, continue to the following steps.
4.
Press on the projector repeatedly to magnify the picture to a desired size.
