Connection 21
• In the connections shown above, some cables may not be included with
the projector (see
). They are
commercially available from electronics stores.
• For detailed connection methods, see pages
.
• For the combination of an active audio in source, see the marks in the
illustration.
Connecting a computer or monitor
Connecting a computer
The projector can connect to both IBM® compatibles and Macintosh® computers. A
Mac adapter is needed if you are connecting legacy version Macintosh computers.
To connect the projector to a notebook or desktop computer
(using VGA):
1.
Take the supplied VGA cable and connect one end to the D-Sub output socket
of the computer.
2.
Connect the other end of the VGA cable to the
PC 1
or
PC 2
signal input jack
on the projector.
3.
If you wish to make use of the projector speaker(s) in your presentations, take a
suitable audio cable and connect one end of the cable to the audio output jack of
the computer, and the other end to the
AUDIO IN
jack of the projector.
When you connect audio output signal from a computer, please balance out the
volume control bar to obtain an optimal sound effects.
To connect the projector to a notebook or desktop computer
(using HDMI):
1.
Take a HDMI cable and connect one end to the HDMI jack of the computer.
2.
Connect the other end of the cable to the
HDMI 1
or
HDMI 2
jack on the
projector.
Many notebooks do not turn on their external video ports when connected
to a projector. Locate a function key labeled CRT/LCD or a function key
with a monitor symbol on the notebook. Press FN and the labeled function
key simultaneously. Refer to your notebook's documentation to find your
notebook's key combination.
Connecting a monitor
If you want to view your presentation close-up on a monitor as well as on the screen,
you can connect the
MONITOR OUT
signal output jack on the projector to an
external monitor following the instructions below:
To connect the projector to a monitor:
1.
Connect the projector to a computer as described in
.
2.
Take a suitable VGA cable (only one supplied) and connect one end of the cable
to the D-Sub input jack of the video monitor.
http://www.pureglare.com.au
