Operation
23
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right is
displayed lasting for 3 seconds, and the
INPUT
PASSWORD
message follows. You can retry by
entering another six-digit password, or if you did not
record the password in this manual, and you absolutely do not remember it, you can use
the password recall procedure. See
"Entering the password recall procedure" on page 23
for details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
Entering the password recall procedure
1.
Press and hold
AUTO
on the projector or
remote control for 3 seconds. The
projector will display a coded number on
the screen.
2.
Write down the number and turn off your
projector.
3.
Seek help from the local BenQ service
center to decode the number. You may be
required to provide proof of purchase
documentation to verify that you are an
authorized user of the projector.
Changing the password
1.
Open the OSD menu and go to the
SYSTEM SETUP: Advanced
>
Security
Settings
>
Change Password
menu.
2.
Press
MODE/ENTER
. The message
“INPUT CURRENT PASSWORD”
appears.
3.
Enter the old password.
i. If the password is correct, another message
“INPUT NEW PASSWORD”
is
displayed.
ii. If the password is incorrect, the password error message is displayed lasting for
three seconds, and the message
“INPUT CURRENT PASSWORD”
is
displayed for your retry. You can press
MENU/EXIT
to cancel the change or
try another password.
4.
Enter a new password.
IMPORTANT: The digits being input will be displayed as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to you should
you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5.
Confirm the new password by re-entering the new password.
6.
You have successfully assigned a new password to the projector. Remember to enter
the new password next time the projector is started.
7.
To leave the OSD menu, press
MENU/EXIT.
Password Error
Please try again.
Please write down the recall code,
and contact BenQ
Customer Center.
Recall Code:
0 2 1 2
RECALL PASSWORD
Exit
