21
Operation
Operation
Starting up the projector
1. Plug the power cord. Turn on the power outlet
switch (where fitted). The power indicator on the
projector lights orange after power has been
applied.
2. Press
on the projector or
on the remote
control to start the projector. The power indicator
flashes green and stays green when the projector is
on.
The start up procedure takes about 30 seconds. In
the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
3. If the projector is activated for the first time, select
your OSD language following the on-screen
instructions.
4. If you are prompted for a password, press the
arrow keys to enter a 6-digit password. See
Utilizing the password function on page 23
.
5. Switch all of the connected equipment on.
6. The projector will search for input signals. The
current input signal being scanned appears. If the
projector does not detect a valid signal, the message “No Signal” will continue displaying until
an input signal is found.
You can also press
SOURCE
to select your desired input signal. See
.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the light source.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
“Out of Range”
displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
