5.1 Testing with an installation tester
Operation
5190 / 04/2021 en
BENNING TA 6
16
5
Operation
You can perform tests with an installation tester.
5.1
Testing with an installation tester
Requirements
• Installation tester BENNING IT 115, IT 130 or IT 200
• Please observe the operating manual of the installation tester used (especially the safety
instructions and warnings contained therein).
• Test object compatible with the device (16 A CEE socket, 3P / N / PE, 400 V, 50 Hz, 5‑pin)
NOTE
Insulating resistance
Measurements of the insulating resistance must be carried out only at test objects which are
free of voltage.
1
2
3
Figure 3:
Connecting the BENNING TA 6
1 BENNING installation tester
2 BENNING TA 6
3 Test object
Procedure
1. Connect the connecting plug of the device to the test connection of the installation tester.
2. Connect the 16 A CEE plug of the device to the test object.
3. Set the desired measuring function on the installation tester.
4. Set the corresponding switch position on the rotary switch of the device.
5. Start the measurement on the installation tester.
6. After having carried out the measurement, save the measuring result (optional).
7. Repeat the described procedure for further intended measurements on the test object.
8. Disconnect the device from the test object after having completed the measurements.