Installation Instructions
Page 1: ...Installation Instructions...
Page 2: ...lower hinge of each actuator to the tab with supplied machine screws Using a straightedge under the hull bottom set the negative angle of the tab s trailing edge as shown SeeFigure2 Step 4 Remove hex...
Page 3: ...finger tight then one full turn with a 1 2 wrench NO MORE Step 10 To connect tubing to Hydraulic Power Units insert tubing through the nut with ferrule fitting and push into the pump face fitting unt...
Page 4: ...tilized for your particular model For the SST system the top portion of the Actuator and the Actuator Shaft are electrically isolated Therefore theTrim Plane and the upper part of the Actuator must be...
