Beninca BRAIN 24, Operating Instructions Manual, Page: 13 / 36

12 13
MENU FUNCTION
Settable values
ON-OFF-(Default)
MEMO
LOGIC
NOlS
The operation mode of the amperometric sensor is selected ei-
ther the limit switches are provided or not.
On: Limit switches not provided. The amperometric sensor
activation is interpreted by the control unit as limit switch. The
control signal is sent to stop the movement. Note: To use this
function, close the limit switch contacts with jumpers. The “SLD”
Logic should be positioned to OFF
Off: Limit switches provided. The amperometric sensor activation
is interpreted by the control unit as obstacle present in the gate
movement area. Similarly to the safety edge activation, the con-
trol signal is sent to stop and reverse movement for approx. 3s.
(OFF)
serL
Service light function is enabled or disabled on output 9-10.
On: at each movement, the contact is closed for approx. 90s.
For the light control use the auxiliary relay (24Vdc/500Ω min) .
Off: The output has the SCA function, open gate LED: open
contact with closed gate, flashing light during gate movement,
closed contact with open gate.
See wire diagram.
(OFF)
ham
Enables or disables the inversion stroke function
On: Function enabled. Before each opening or closing manoeuvre
the control unit orders a manoeuvre of 2s in the opposite direction
to facilitate the release of the electric lock.
Off: Function disabled.
(OFF)
MENU FUNCTION
NMAN
Displays the number of complete cycles (open+close) carried out by the automation.
When the <PG> button is pressed for the first time, it displays the first 4 figures, the second time it
shows the last 4. Example <PG>
0012
>>> <PG>
3456
: made 123.456 cycles.
RES
RESET of the control unit. ATTENTION!: Returns the control unit to the default values.
Pressing the <PG> button for the first time causes blinking of the letters RES, pressing the <PG> but-
ton again resets the control unit.
Note: The transmitter codes are not erased from the receiver.
EXAMPLE OF PROGRAMMING
Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s
- activate pre-blinking
Perform the operations described below step by step:
Step Press Display Notes
1
PAR
First menu
2
TCA First function of the first menu
3
040
Value currently set for the function selected
4
100
Set the desired value with the <+> and <-> keys
5
PRG The value is programmed
TCA
When programming has been made, the display goes to the function just set
6
PAR
Press <+> and <-> simultaneously to go to the higher menu
7
Log Second menu
8
TCA
First function of the second menu
9
Pre
Press <-> several times to select PRE logic
10
OFF
Value currently set for the function selected
11
ON Set the desired value with the <+> and <-> keys
12
PRG
The value is programmed
Pre
When programming has been made, the display goes to the function just set
13
PAR
Press <+> and <-> simultaneously to go to the higher menu and quit programming or wait
30s.
www.ga
ł
ecki.pl