11
TECHNICAL DATA
Power supply
Tao 3V lithium batteries (Li)
CR123A (1400mAh)
Range without obstacles
100m
Operating frequency
433,92 MHz
Operating temperature
-20°C / +70°C
Number of storable codes
254
Protection level
IP55
Overall dimensions
see Fig.1
Wall installation (Fig. 2)
BE.TOUCH can be applied to wall through
washers and plugs supplied.
WARNING: As the various programming phases
require an access to the radio receiver of the
system, it is advisable to fix the keypad to wall
only after programming all functions.
The IP55 protection level permits to use the
keypad also on walls that are not protected
against weather agents. It is however advisable,
whenever possible, to apply the system on a
protected wall.
In any case, it is mandatory to apply the G
gasket between wall and container.
1 Open the container by loosening the screw
H.
2 Apply the bottom of the container to wall
by using either the two plugs T and the two
screws C, if a masonry support is provided,
or self-tapering screws, if a metal support of
provided: in any case, use a fixing suitable
to the support.
3 Close the container.
How to replace the batteries (Fig. 3)
Open the container by removing the screw H,
Fig.2.
A battery removable cover is supplied on the
rear part, fixed with the two screws Y, Figure
3.
Always replace both batteries with new batter-
ies CR123A, taking care of poles.
Duration of the batteries
The battery life always depends on the fre-
quency of use. The following table indicates
the indicative life of batteries according to
their use:
No. of activations/day *
Foreseen battery life** (years)
0
6,5
2
6
5
5
10
4
*Activations of around 10 seconds
**Average temperature: 25°C
PROGRAMMING
Before proceeding to the programming of the
system, some aspects of the operating princi-
ples must be highlighted.
Before programming, carefully read all instruc-
tions.
Access password
The programming of the device is protected
by an access password which should be im-
mediately customized.
The factory-preset password is 123456.
Take note of the new password and keep
it in a safe place for future uses. If the
password is lost, the device will have to be
entirely reset, and all memorised codes will
be removed.
Father Code / Child Code
BE.TOUCH behaves substantially as a standard
radio transmitter. It sends the receiver a code
which is similar to the code that is sent by
pocket remote controls.
For an easier management of the system,
BE.TOUCH can store various digital codes
from the numeric keypad and match them to
one single radio code.
111111
222222
333333
444444
555555
9999999
In this example, the “Father” code 999999
i s m a t c h e d t o v a r i o u s “ C h i l d ” c o d e s
(1111111/222222/etc.). In this way, new Child
codes can be included at any moment by acting
directly on BE.TOUCH, without having access
to the receiver.
In any case, the Father code must be stored in
the receiver memory.
